Notes：For raw material,if its volume has great change before and after dry,then its filling coefficient may be increased or decreased suitably.
Speed adjusting motor of 0-6rpm might be chosen according to the user’s requirements. The following aspects should be pointed out when to order:
1.The above-mentioned parameters are calculated based on material density of 0. 6g/cm3.If it's over, please point out.
2. If certificate for pressure vessel is required, please point out.
3. If glass lining for interior surface is required, please point out.
If the material is explosive, or flammable, the calculation should be made according to trial result.
Notice in order
Its heating has three ways i.e. steam, hot water, heat conduction oil.
When order, please indicate the temperature of raw material to be undertaken or the operation temperature of drier in order to choose or provide suitable heat source for you
When dry viscous raw material, our factory will design special stirring device in the chamber.
The auxiliary parts of vacuum drying system can be supplied and installed by our factory. Please indicate them when order.
If having special requirements, our factory can also design, manufacture and install as request.
The cost of complete equipment should be increased in accordance with the needs.